Quick start guide EL42208/EL42308/EL42408/ EL42258 5.8 GHz cordless telephone/ answering system with caller ID/call waiting MENU / SEL TRANSFER MENU / SEL TRANSFER ANNC.
Installation preparation If you subscribe to high-speed Internet service (Digital Subscriber Line - DSL) through your telephone lines, you must install a DSL filter between the telephone base and the telephone wall jack. The filter will prevent noise and caller ID problems caused by DSL interference. Please contact your DSL service provider for more information about DSL filters. Your product may be shipped with a protective sticker covering the handset or telephone base display - remove it before use.
Telephone base and charger installation If you subscribe to high-speed Internet service (Digital Subscriber Line - DSL) through your telephone lines, you must install a DSL filter between the telephone base and the telephone wall jack. The filter will prevent noise and caller ID problems caused by DSL interference. Please contact your DSL service provider for more information about DSL filters. Install the telephone base and charger as shown below. Telephone base installation 2.
Battery installation & charging Install the battery as shown below. After installing the battery, you can make and receive short calls, but replace the handset in the telephone base or charger when not in use. For optimal performance, charge the handset battery for at least 16 hours before use. When fully charged, the handset battery provides approximately five hours of talk time or six days of standby time.
Quick reference guide - handset CHARGE The light is on when a cordless handset is properly positioned to charge in the telephone base or charger. MENU/SEL/TRANSFER Press to display menu. Press to store a programming option. During a call, press to transfer a call between handsets. DIR /VOLUME+ When in a menu, press to scroll up. When the phone is not in use, press to display directory entries. While entering names, press to advance the cursor. During a call, press to increase listening volume.
Quick reference guide - telephone base IN USE • On steady when a handset is in use. • Flashes quickly while an incoming call is ringing. ANNC. HANDSET LOCATOR Press to make the handset beep when a handset is not on the telephone base. RECORD PLAY/STOP MESSAGE COUNTER Number of messages (or during playback, message number currently playing). Press to start or stop message playback. SKIP Press to skip message. REPEAT Press to repeat message; press twice to play previous message.
www.telephones.att.com © 2008 Advanced American Telephones. All rights reserved. AT&T and the AT&T logo are trademarks of AT&T Intellectual Property II, L.P. d/b/a AT&T Intellectual Property licensed to Advanced American Telephones. Printed in China. Issue 6 AT&T 08/08.
