5.8 GHz Cordless Telephone/Answering System with Caller ID/CallWaiting User's Manual E5933B, E5934B

48
Appendix
Incomplete 
messages
•  If a caller leaves a very long message, part of it may be lost when the 
system disconnects the call after four minutes.
•  If the caller pauses for more than seven seconds, the system stops 
recording and disconnects the call.
•  If the system’s memory becomes full during a message, the system 
stops recording and disconnects the call.
•  If the caller's voice is very soft, the system may stop recording and 
disconnects the call.
Difficulty hear-
ing messages
•  Press VOLUME ^ to increase speaker volume.
System does 
not answer after 
correct number 
of rings
•  Make sure that the answering system is on (see page 28).
•  If toll saver is activated, the number of rings changes to 2 when you 
have new messages waiting (see page 32).
•  In some cases, the system may be affected by the ringing system 
used by the local telephone company.
•  If the memory is full or the system is off, the system will answer after 
10 rings.
CL flashes in 
message win-
dow
•  You need to reset the answering system clock (see page 29).
System does 
not respond  
to remote  
commands
•  Make sure to enter your remote access code correctly (see page 36).
•  Make sure you are calling from a touch-tone phone. When you dial a 
number, you should hear tones. If you hear clicks, the phone is not a 
touch-tone telephone and cannot activate the answering system.
•  The answering system may not detect the remote access code while 
your announcement is playing. Try waiting until the announcement is 
over before entering the code.
•  There may be noise or interference on the phone line you are using. 
Press dial-pad keys firmly.
Troubleshooting
System does 
not record  
message
•  Make sure answering system is on (see page 28).
•  Make sure announcement only is off.
Announcement 
message is not 
clear
•  When you record your announcement, make sure you speak in a 
normal tone of voice, about 9 inches from the base.
•  Make sure there is no background noise (TV, music, etc.) while you 
are recording.










