Quick start guide 5.
Battery installation & charging After battery installation, the battery may have enough charge to allow for some calls. For best performance, place the handset(s) in the telephone base or charger(s) and allow to charge for 16 hours before use. You can keep the battery charged by returning the handsets to the telephone base or chargers after each use. When the battery is fully depleted, a recharge takes about 12 hours.
Getting started Choose a location for your telephone Choose a central location close to a telephone jack and a power outlet not connected to a wall switch. The telephone base can be placed on a flat surface or mounted on a standard wall plate. For optimum range and better reception, place the telephone base in a high and open location.
Quick reference guide UP Cordless handset CENTER LEFT CID Press to display caller ID information. RIGHT DOWN MENU������� /������ SELECT Press to display the menu. Once in the menu, press to select an item or save an entry or setting. Press or to scroll up or down while in menus. While entering names or numbers, press or to move the cursor to the left or right. PHONE/FLASH Press to make or answer a call. During a call, press to receive an incoming call if call waiting is activated.
Quick reference guide Telephone base CHARGE/IN USE • Flashes when another telephone on the same line and on steady when one of the handsets is in use. • On steady when the answering system is answering an incoming call. • Flashes while an incoming call is ringing. • On steady when the handset is properly positioned to charge in the telephone base. VOICEMAIL Flashes when you have new voice mail (requires voice mail service from your local telephone company. HANDSET LOCATOR Press to make handsets beep.
www.telephones.att.com Copyright © 2006 Advanced American Telephones. All rights reserved. AT&T and the Globe symbol are trademarks of AT&T Knowledge Ventures, Licensed to Advanced American Telephones. Printed in China. Issue 2 AT&T 12/06.