User`s manual

Telephone operation

INTERCOM TO:

Intercom

Use the intercom feature for conversations between

handsets.

1. Press INT. The screen of the originating handset

will show INTERCOM TO:.

2. Enter the destination handset number. The

display will show CALLING HANDSET X. The

destination handset will ring, and its screen

will show HANDSET X IS CALLING.

NOTES:

• Before the intercom call is answered, you can cancel the

intercom call by pressing OFF/CLEAR or INT.

• If the destination handset is not answered within 100

seconds or if it is in the directory or call log mode, or out

of range, the originating handset will show the message

UNABLE TO CALL TRY AGAIN.

3. On the ringing destination handset, press INT,

PHONE/FLASH, SPEAKER, or any dial pad

key (0-9, * or #) to answer the intercom call.

NOTE: Pressing OFF/CLEAR or MUTE/DELETE will tempo-

rarily silence the intercom ringer.

To end the intercom call:

• Press OFF/CLEAR or INT on either handset.

-OR-

• Place either handset in the charger or telephone

base.

Handling incoming calls

The telephone will beep if there is an outside call

during an intercom conversation. You can either:

• Press PHONE/FLASH to end the intercom call

and answer the incoming call.

-OR-

• Press INT or OFF/CLEAR to disconnect the inter-

com connection without answering the incoming

call. The incoming call will continue to ring.

NOTE: A maximum of

two handsets can be

used on an intercom

call at the same time,

and another handset

can be used on out-

side call at the same

time.