User`s manual

You may be able to
make and receive
short calls. For best
performance, place the
handset in telephone
base to charge for at
least 16 hours before
first use.
TONE
MUTE
DELETE
REDIAL
PAUSE
FLASH
CLEAR
Installation and setup
NOTES:
1. Use only the power adapter supplied with this prod-
uct. To order a replacement power
adapter, visit our website at
www.telephones.att.com or call 1
[phone]. In Canada dial 1
[phone].
2. Be sure to use an electrical outlet not controlled by a wall
switch.
3. This power unit is intended to be correctly oriented in
a vertical or floor mount position. The prongs are not
designed to hold the plug in place if it is plugged into a
ceiling, under-the-table or cabinet outlet.
4. If you receive high speed internet through your telephone
line (commonly referred to as DSL), and you are experiencing
interference during telephone conversations and/or your
caller ID features are not functioning properly, install a DSL
filter to the telephone line between the telephone base
and the telephone wall jack. Contact your DSL service provider
for a DSL filter.
Telephone line cord
DSL filter
(Optional for DSL users,
see number four in the
note section below.)
1
2
3
4
5
1. Plug one end of the telephone line
cord into the telephone jack at the bot-
tom of the telephone base.
2. Plug the small end of the power
adapter into the power jack at the
bottom of the telephone base.
3. Route cords through slots.
4. Plug the large end of the power
adapter into an electrical outlet not
controlled by a wall switch.
5. Plug the other end of the telephone
line cord into a telephone wall jack.
2