User Guide
Table Of Contents
- E2525 manual
- Table of contents
- Quick reference guide
- Parts checklist
- Before you begin
- Telephone base installation
- Battery installation & charging
- Wall mounting
- Connect cords as shown, then press and slide down firmly so base is held securely on outlet mounting pegs
- Clip wall-mount bracket securely into notches on underside of base
- Plug short telephone line cord into telephone jack
- Plug power cord transformer into electrical outlet
- Place handset in base to charge for 8 hours before first use.
- Belt clip & optional headset
- Telephone Operation
- Phonebook
- Caller ID Logs
- Answering System Operation
- Appendix
- Display screen status icons
- Alert tones and indicator lights
- Adding new handsets
- Charging spare batteries
- In case of difficulty
- Telephone does not work at all
- Phone does not ring
- If you hear noise or interference during a call
- If you lose a call while using the handset
- Incomplete messages
- Difficulty hearing messages
- System does not answer after correct number of rings
- “CL” appears in message window
- System does not respond to remote commands
- Announcement message is not clear
- Index
- Technical specifications
- Remote access wallet card
- IMAGES
- E250 manual
34
Appendix
Display screen status icons
Handset status icons
Phone in use (external call)
Phone in use (intercom call); flashes when handset is being paged
Battery power level (see below)
Ringer off
R
Handset is not yet registered, or searching for base
Base status icons
Spare battery charging (animated display)
Ringer off
Battery power levels
Battery fully charged
Approximately half power remaining
Battery power is low; should be recharged soon
(flashing) Battery power is very low and must be recharged
1
Answering system is receiving an incoming call
Phone in use (external or intercom call); 1-8 = handsets, 0 = base
M
Microphone is muted
H
Call is on hold
T
HANDSET 1
REDIAL MEM
MENU
MENU
ATT-2525CIB-d2.qxd 12/30/2003 6:30 PM Page 34