Technical information

Administering the SVN Feature
Issue 7 June 2001
12-5
 Login Threshold
Enter the minimum number of login attempts that will be permitted
before a referral call is made. The value assigned to this field, in
conjunction with the Time Interval field, determines whether a
security violation has occurred. The system default is 5.
 Time Interval
Enter the time interval within which a login security violation must
occur. The range is one minute to eight hours (0:01 to 7:59), and is
entered in the form x:xx. For example, if you want the time interval to
be 1 minute, enter 0:01. If you want the time interval to be seven
and one-half hours, enter 7:30. The system default is 0:03.
 Announcement Extension
Enter an extension that is assigned to the Remote Access SVN
announcement. The announcement must be recorded for the SVN
referral call to be made. A repeating announcement is suggested,
especially if the SVN referral call might go to an answering machine.
3. To activate the Disable Following a Security Violation feature, display the
Remote Access Form and enter
y in the Disable Following a Security
Violation field.
4. For releases before G3V3, administer an “rsvn-call” button on any
station/attendant console (maximum 1 per system). The SVN button
location can be determined by entering the command display
svn-button-location. Activation of this feature button initiates the
placement of remote access referral calls, until the button is deactivated.
5. For G3V3 and later releases, administer an “rsvn-halt” button on any
station/attendant console (maximum 1 per system). The SVN button
location can be determined by entering the command
display
svn-button-location
. Activation of this feature button stops the placement
of all remote access referral calls until the button is deactivated.
Enable/Disable Remote Access Code
To enable a Remote Access Code that has been disabled following a security
violation, or disabled manually with the
disable remote access command:
1. Log in to the switch using a login ID with the proper permissions.
2. Enter the command
enable remote access.
To disable a Remote Access Code:
1. Log in to the switch using a login ID with the proper permissions.
2. Enter the command
disable remote access.