System information

Assign a Data Link
Issue 1 October 1997
3-15
275 Word 3
Use this procedure to record the local switch number and check the Caller
Response Interval and the Coverage Point Don’t-Answer Interval.
Press and .
258 Word 1
Use this procedure to ensure the scratch pad is unprotected.
1. From Worksheet D: Assign the Data Link. Verify that this is set to the correct number of
2-sec intervals. This determines the delay in transfer to the next coverage point. This
delay, which causes a period of silence between the final ring at the subscriber’s voice
terminal and the first ring at the first coverage point, should not be so long as to cause
the calling party to feel that the call has been dropped.
2. From Worksheet D: Assign the Data Link. Verify that this is set to the correct number,
1-8, of ringing cycles. Local requirements determine the number of ringing cycles
before the call continues to the next coverage point. This number must equal the Don’t
Answer Timing Interval number of ringing cycles specified in Proc 200 Word 1 Field 4.
This number applies to ringing at the coverage points, not at the subscriber’s voice
terminal. The number of ringing cycles before coverage is determined on an individual
group basis in Procedure 011, Word 1, Field 6.
1. If Field 2 does not display 0, enter 1 in Field 1 and press and to
change field 2 to 0.
Field Manager II Field Name Action
3 Caller Response Interval
1
4 Coverage Point DA Interval
2
8 Local Switch Number Record this number (if dashed, record 1)
10 Call Control FRL Record this number.
Field Manager II Field Name Action
2 Configuration Check that the number = 0
1
CHANGE EXECUTE
CHANGE EXECUTE