System information

Assign Voice Ports and the INTUITY AUDIX System ACD
Split
Issue 1 October 1997
3-9
001 Word 1
Administer the extensions associated with existing extensions. These associated
extensions provide access to ACD splits unless your system uses vectoring.
NOTE:
Do not assign an extension that was assigned already in Procedure 000,
Word 1.
The I
NTUITY AUDIX system associated extension should be a Direct Inward
Dialing (DID) type so outside users can reach the I
NTUITY AUDIX system.
Administer this procedure before going to Procedure 026, Word 2.
Press and .
If your switch has been previously assigned, error code 12 may display when the
associated extension number is assigned already as an extension number.
Remove this extension as a primary extension number by doing the following:
1. Go to Procedure 000, Word 1.
a. Set Field 1 (Extension or VDN) to the primary extension number.
b. Press , , , and .
2. Go to Procedure 003, Word 1.
a. Set Field 1 (Extension) to the [primary extension #].
b. Press and .
c. Set Field 2 (Days Remaining in Recent Disconnect) to 0
3. Press and .
1. Enter the extension number assigned to the INTUITY AUDIX system split
member 0 (the I
NTUITY AUDIX system voice port number 1). From
Worksheet B: Voice Port Extensions and Names
2. Enter the number dialed by the INTUITY AUDIX system subscribers to
access the I
NTUITY AUDIX system. From Worksheet C: Assign the INTUITY
AUDIX Split. Do not enter if vectoring is used.
Field Manager II Field Name Enter
1 Primary Extension [extension]
1
2 Associated Extension [extension]
2
ADD EXECUTE
DISPLAY EXECUTE
REMOVE
EXECUTE
DISPLAY EXECUTE
CHANGE
EXECUTE