System information

Switch Integration Planning
2-12 Issue 1 October 1997
Worksheet G: Assign a Split at the Remote Switch
Use this worksheet (Table 2-7) to plan the split on each remote switch in the DCS
network.
Table 2-7. Worksheet G: Assign a Split at the Remote Switch
1. If the remote switch uses vectoring, unanswered calls can simply go to a VDN for
coverage. The VDN can then terminate at a vector. The vector should contain a
”route-to” step that routes to the I
NTUITY AUDIX system (via a QDN or AD list
number). A “stop” step should then immediately follow the route-to step.
Date:
Prepared By:
Contact Telephone Number:
Item Your Entry
COS for ACD Split on Remote Switch
Enter the COS number of members of the ACD split.
Unanswered calls to subscribers on the remote switch
will go to coverage to this split. Calls are then
forwarded to the I
NTUITY AUDIX split on the host
switch.
1
Extension of Split Member 0
Enter an extension for member 0 in the split.
Queuing Trunk Group Number
Enter the number of the trunk group that will carry
calls to the ACD split.
ACD Split Number
Enter the split number on the remote switch to which
subscribers will queue when calling or forwarding to
I
NTUITY AUDIX.
ACD Split Extension
Enter the extension to which unanswered calls to
remote subscribers go for coverage on the remote
switch. From this coverage point, calls are then
forwarded to the I
NTUITY AUDIX on the host switch.