System information

Copyright  1997, Lucent Technologies
All Rights Reserved
Printed in U.S.A.
Notice
Every effort was made to ensure that the information in this book was com-
plete and accurate at the time of printing. However, information is subject
to change.
Your Responsibility for Your System’s Security
Toll fraud is the unauthorized use of your telecommunications system by an
unauthorized party, for example, persons other than your company’s
employees, agents, subcontractors, or persons working on your company’s
behalf. Note that there may be a risk of toll fraud associated with your tele-
communications system and, if toll fraud occurs, it can result in substantial
additional charges for your telecommunications services.
You and your system manager are responsible for the security of your sys-
tem, such as programming and configuring your equipment to prevent
unauthorized use. The system manager is also responsible for reading all
installation, instruction, and system administration documents provided
with this product in order to fully understand the features that can introduce
risk of toll fraud and the steps that can be taken to reduce that risk. Lucent
Technologies does not warrant that this product is immune from or will pre-
vent unauthorized use of common-carrier telecommunication services or
facilities accessed through or connected to it. Lucent Technologies will not
be responsible for any charges that result from such unauthorized use.
Lucent Corporate Security
Whether or not immediate support is required, all toll fraud incidents
involving Lucent products or services shoud be reported to Lucent Corpo-
rate Security at 1 800 821-8235. In addition to recording the incident,
Lucent Corporate Security is available for consultation on security issues,
investigation support, referral to law enforcement agencies, and educational
programs.
Lucent Technologies Fraud Intervention
If you suspect that you are being victimized by toll fraud and you need tech-
nical support or assistance, call Technical Service Center Toll Fraud Inter-
vention Hotline at 1 800 643-2353.
Federal Communications Commission Statement
Part 15: Class B Statement. This equipment has been tested and found to
comply with the limits for a Class B digital device, pursuant to Part 15 of
the FCC Rules. These limits are designed to provide reasonable protection
against harmful interference in a residential installation. This equipment
generates, uses, and can radiate radio-frequency energy and, if not installed
and used in accordance with the instructions, may cause harmful interfer-
ence to radio communications. However, there is no guarantee that interfer-
ence will not occur in a particular installation. If this equipment does cause
harmful interference to radio or television reception, which can be deter-
mined by turning the equipment off and on, the user is encouraged to try to
correct the interference by one or more of the following measures:
• Reorient the receiving television or radio antenna where this may be
done safely.
• To the extent possible, relocate the receiver with respect to the tele-
phone equipment.
• Where the telephone equipment requires AC power, plug the tele-
phone into a different AC outlet so that the telephone equipment and
receiver are on different branch circuits.
Part 15: Personal Computer Statement. This equipment has been certi-
fied to comply with the limits for a Class B computing device, pursuant to
Subpart J of Part 15 of FCC Rules. Only peripherals (computing input/out-
put devices, terminals, printers, etc.) certified to comply with the Class B
limits may be attached to this computer. Operation with noncertified
peripherals is likely to result in interference to radio and television recep-
tion.
Part 68: Network Registration Number. This equipment is registered
with the FCC in accordance with Part 68 of the FCC Rules. It is identified
by an FCC registration number.
Part 68: Answer-Supervision Signaling. Allowing this equipment to be
operated in a manner that does not provide proper answer-supervision sig-
naling is in violation of Part 68 Rules. This equipment returns answer-
supervision signals to the public switched network when:
• Answered by the called station
• Answered by the attendant
• Routed to a recorded announcement that can be administered by the
CPE user
This equipment returns answer-supervision signals on all DID calls for-
warded back to the public switched telephone network. Permissible excep-
tions are:
• A call is unanswered
• A busy tone is received
• A reorder tone is received
Canadian Department of Communications (DOC)
Interference Information
This digital apparatus does not exceed the Class A limits for radio noise
emissions set out in the radio interference regulations of the Canadian
Department of Communications.
Le Pr
ésent Appareil Nomérique n’émet pas de bruits radioélectriques
d
épassant les limites applicables aux appareils numériques de la class A
pr
éscrites dans le reglement sur le brouillage radioélectrique édicté par le
minist
ére des Communications du Canada.
Trademarks
See the section titled “About This Book.”
Ordering Information
Call: Lucent Technologies Publications Center
Voice 1 800 457-1235 International Voice 317 361-5353
Fax [phone] International Fax [phone]
Write: Lucent Technologies Publications Center
P.O. Box 4100
Crawfordsville, IN 47933
Order: Document No. 585-310-256
Comcode 108099615
Issue 1, October 1997
You can be placed on a standing order list for this and other documents you
may need. Standing order will enable you to automatically receive updated
versions of individual documents or document sets, billed to account infor-
mation that you provide. For more information on standing orders, or to be
put on a list to receive future issues of this document, contact the Lucent
Technologies Publications Center.
Warranty
Lucent Technologies provides a limited warranty on this product. Refer to
the “Limited Use Software License Agreement” card provided with your
package.
European Union Declaration of Conformity
Lucent Technologies Business Communications Systems declares that the
equipment specified in this document conforms to the referenced European
Union (EU) Directives and Harmonized Standards listed below:
EMC Directive 89/336/EEC
Low-Voltage Directive 73/23/EEC
The “CE” mark affixed to the equipment
means that it conforms to the above
directives.
Comments
To comment on this document, return the comment card at the front of the
document.
Acknowledgment
This document was prepared by Product Documentation, Lucent Technolo-
gies, Columbus, OH.