System information

Cut-to-Service Administration
7-2 Issue 1 October 1997
administration, and acceptance tests must be completed before you cut the
system into service. To perform the cut-to-service process, you must perform the
following two tasks:
■ Administer the coverage path.
■ Administer the subscriber stations.
Continue with the procedures in this chapter to administer the switch for the
cut-to-service.
Use the following procedures to cut the Lucent I
NTUITY system into service. The
procedure describes how to administer the subscribers on the switch and enable
them to use the Lucent I
NTUITY system. Complete this task when you are ready to
place the subscribers into service. Make sure that all tasks in your installation
document, are complete before performing the subscriber administration.
You may do the procedures described in this chapter using any of the following
switch administration tools:
■ Maintenance and Administration Panel (MAAP)
■ Manager II, III, or IV
Subscriber administration on the switch includes:
■ Defining a coverage path with the Lucent INTUITY system (split) hunt group
as a coverage point
■ Changing the feature options to enable Leave Word Calling (LWC)
reception to the Lucent I
NTUITY system
Assign Switch Features for INTUITY
AUDIX® System Subscribers
To put the INTUITY AUDIX system into service for your subscribers, you must
assign them the appropriate switch features and the coverage path to the I
NTUITY
AUDIX system. Table 7-1 summarizes procedures on this cut-to-service
administration.