System information

Administer the Lucent INTUITY System for a Non-DCS
Switch Integration
Issue 1 October 1997
5-3
5. Select DCIU Interface Administration (at the Switch Interface
Administration menu).
The system displays the DCIU Interface Administration window
(Figure 5-2).
Figure 5-2. DCIU Interface Administration Window
When you access the screen, the cursor appears in the Extension
Length field. (The Switch Link Type and Switch Release fields are
display only.) When the switch integration software was installed, the
switch link type and switch release information were entered. You cannot
change the information in these fields. For more information on the
installation process, see the installation document for your I
NTUITY system.
6. Enter an extension length of, 3, 4, or 5, of the dial plan in the Extension
Length field. See ‘‘Worksheet B: Voice Port Extensions and Names’’ in
Chapter 2, ‘‘Switch Integration Planning’’ to determine the extension
length.
7. Enter the number of the host switch in the Host Switch Number: field.
Valid host switch numbers range from 1 to 20.
8. Enter the logical channel number in the AUDIX Port Logical Channel
field. Logical channels range from 1 to 64.
The logical channel is the same number as the Interface Link and the
Local DCIU Port Number on the switch. See ‘‘Worksheet D: Assign the
Data Link’’ in Chapter 2, ‘‘Switch Integration Planning’’ to find the number.
9. Enter the switch port in the AUDIX Port Switch Port field. Valid switch
port numbers range from 1 to 64.