Instruction manual

HARDWARE AND SOFTWARE DETERMINATION

TONE CLOCK (TN768)

For G1 and G3, Tone Clock TN768 is always required instead of TN741 or TN714. G1 and G3

multi-carrier cabinets ship with a TN768 as part of the basic PEC. G1 single-carrier cabinets ship

with a TN756 as part of the basic PEC. When a G1 single-carrier cabinet system has the dupli-

cation option, EPN, DS1 service, or OCM, a TN768 Tone Clock (PEC 65515) is required.

When either a TN741 or TN768 is used, the Tone Detector must be the TN748.

TONE CLOCK (TN780)

The TN780 connects and monitors an optional external Stratum 3 clock. The TN780 also cou-

ples the Stratum 3 clock’s output to local clocks. Only the processor carrier, which supplies mas-

ter timing to the system, uses this circuit pack. The TN780 provides the following tones: call pro-

gress, touch tones, answer-back, and trunk transmission test. It also provides the following

clocks: 2MHz, 160kHz, and 8kHz. This circuit pack can transmit the system clock and tones on

either TDM bus A, TDM bus B, or both buses.

TONE DETECTOR (TN748)

Two Call Progress Tone Receiver (CPTR) ports are provided on each TN748 Tone Detector cir-

cuit pack alongside the four Touch-Tone Receiver ports. CPTRs are required to provide dial tone

detection for the enhanced Automatic Route Selection, Terminal Dialing, Abbreviated Dialing, and

Last Number Dialed features. High usage of Terminal Dialing to locations outside the system

may require a greater number of CPTRs and should be referred to your Technical Service Center

(TSC) for review.

Note that up to 20 TN748s my be used in G1 systems, up to 10 in G3i systems, and up to 50 in

G3r systems.

In the following calculations, do not include TN748s that are provided as standard equipment.

Note: For G1 single-carrier systems, the TN768 Tone Clock circuit pack is used instead of

the TN756 Tone Detector/Generator circuit pack when the duplication option, DS1

Tie Trunk (TN722), or DS1 Interface (TN767) circuit packs or ISDN-PRI is used.

Enter the number of:

(A) Touch-Tone Receivers ............................................................................................ ____

SUBTOTAL A ÷ 4 = ____

(B) Call Progress Receivers.......................................................................................... ____

SUBTOTAL B ÷ 2 = ____

PEC

ENTER LARGER OF SUBTOTALS ____ 63123