Instruction manual

FEATURE DETERMINATION

TABLE B

(continued).

Features Requiring Additional Hardware and/or Software

Hardware and/or Actual

Feature Software Hardware and/or

Required Software Needed

Station Identification/

Automatic Number Identif -

ication (SID/ANI) (G1

name) Calling Party

Number/Billing Number

(CPN/BN) (G3)

For G1 or G3i, assign an Interface Link

(requires a TN765 Processor Interface cir -

cuit pack) for a direct EIA-232 connection

(if not already used). Alternately, a data

module and TN754 Digital Line port (for G1

and G3i) can be used. For G3r or G1.2SE,

TN464 Universal DS1 circuit pack (for G3r

or G1.2SE) is used. Note that the link is

administered on the System’s Processor

Channel Assignments form. The link is

used as an interface to a CallVisor ISDN

Gateway adjunct (3B2 Processor) in support

of SID/ANI (G1) or CPN/BN (G3). Requires

display terminals.

Requires ACD-related hardware also. Refer

to the ACD feature coverage elsewhere in

this table.

Requires ISDN-PRI software and CallVisor

ISDN Gateway software.*

Requires Service Observing Software.*Service Observing

Subnet Trunking Additional TN748 circuit packs, if Routing

Patterns containing ‘‘wait’’ symbols are used

heavily, and if dial tone detection is prefer -

able to waiting for interval time-out.

Private Networking, UDP, or ARS software.

DCS software is optional.

Ten-Digit to Seven-Digit

Conversion (G1 Only)

Either ARS and Private Networking software

or ARS and UDP software.

Time of Day Routing Time of Day Routing software. ARS

software.

Uniform Dial Plan (UDP) UDP software.

* Software is activated by enabling this feature on the System Parameters Customer Options form.