Instruction manual

FEATURE DETERMINATION

TABLE B

(continued).

Features Requiring Additional Hardware and/or Software

Hardware and/or Actual

Feature Software Hardware and/or

Required Software Needed

Automatic Wakeup If voice prompting is used, a TN725 Voice

Synthesizer circuit pack is required. Each

circuit pack has four ports to provide voice

prompting. If voice synthesis announce -

ments are used, two ports must be reserved

for announcements.

For customized recorded announcements, a

model HQD614B Recorder/ Announcer

manufactured by the Audichron  Company

is required. This equipment requires a

48-volt power supply. Each Recorder/

Announcer requires four auxiliary trunk ports

on the TN763 Auxiliary Trunk circuit pack.

Basic Call Management

System (BCMS)

BCMS Measurements software.*

Call-By-Call Service

Selection

For G1 or G3i, a TN767 DS1 circuit pack,

TN768 Tone Clock circuit pack, and a

TN765 Processor Interface circuit pack.

For G3r, a TN464 Universal DS1 circuit

pack, TN768 Tone Clock, and a TN553

Packet Data circuit pack.

Requires ARS software and ISDN-PRI

software.*

Call Detail Recording

(CDR)

Hardware requirements depend on the type

of output device used for CDR. For G3i, the

CDR output device can be connected

directly to the Processor circuit pack

(TN759 or TN773) which provides a stan -

dard EIA-232C interface. This eliminates the

need for a data module as described for the

output devices given below. For G3r, the

CDR output device is connected to a TN553

Packet Data circuit pack, which is connected

to a TN726 Data Line circuit pack.

* Software is activated by enabling this feature on the System Parameters Customer Options form.