Instruction manual
INTRODUCTION
How to Use This Document
This document is written to lead you, step by step, through the planning and configuration pro-
cess. Detailed instructions are given throughout the document. The following list is a brief sum-
mary of the steps to be followed when planning and configuring your system.
1. Use Table A to identify all desired features.
2. Use Table B to determine any additional hardware and/or software that may be required
for specific features.
3. Review Tables C and D. These tables, in conjunction with information derived from
Tables A and B, should be helpful in determining which version of the system is needed.
4. Use Table E to list the system users and their individual equipment needs.
5. Use Table F to determine the total number of each type of voice and data terminals.
Information for this table is obtained from Table E.
6. Use Table G to determine the total number of each type of voice and data terminal
adjunct. Information for this table is obtained from Table E.
7. Use Table H to determine if any of the terminal equipment limits have been exceeded.
8. Review the data communications equipment information that is provided.
9. Use Table I to list the quantities of data communications equipment.
10. Determine if traffic engineering calculations should be made.
11. Use Table J to determine which data terminals are needed, and in particular the Manager
I or G3r-Management Terminal (G3r-MT).
12. Use Table K to determine which system printer is needed.
13. Determine the number of each type of network access facility to be used per Table L.
14. Determine the number of each type of circuit pack to be used and list the totals in
Table M.
15. Determine the combination of cabinets for DEFINITY Generic 1 using the tables in
‘‘Multi-Carrier Cabinet Configuration’’ and ‘‘Single-Carrier Cabinet Configuration.’’
16. Complete the ordering information using the information listed in the tables that have
already been filled out.
17. Review the following sections so that any necessary equipment room preparations and
advance planning considerations can be made for the new system.
‘‘Environmental Requirements’’
‘‘Power and Grounding’’
‘‘Upgrades and Additions’’
4