User`s manual

Data Options and Profiles
Storing an Active Profile, pA
If you want to save the active profile as a stored profile, type: copy pA to p2
The above command stores your active profile in p2. The system responds:
p2 updated
If you want to store your active profile in p1, repeat the steps above but
substitute p1 for p2. Remember, in pA you cannot program your options; the
settings in pA, therefore, are not automatically stored. You must copy pA to a
stored profile (p1, p2, p3, or p4) so your active profile is not lost in the event of a
power failure.
Activating a Stored Profile
To activate a stored profile, type the following command at the CMD: prompt:
copy profile to pA
For example, to activate p1, type: copy p1 to pA . The ADM activates the profile
requested and responds:
pA updated
Replacing One Stored Profile with Another
To replace one stored profile with another, type copy replacement profile to
replaced profile . For example, type: copy p0 to p1 replaces the values of p1
with the values of p0.
4-26