User`s manual

Data Options and Profiles
Creating (Programming) a Data Option
Profile
It is possible for you to program profiles p1, p2, p3, and p4. Profile 1 (p1) is
automatically loaded after a set self-test or power-up. The values of p1 should
be set to your most frequently used settings.
To change the option values of any of the stored profiles use the program
command. The program command provides a series of prompts to help you with
this task.
The program command cannot be used to change option values in the active
profile or the factory profile p0. To change the active profile, use the set
command (see a later section in this chapter, ‘‘Setting Options: Changing Your
Active Profile pA’’).
NOTE:
Speed and parity options can only be changed from your data terminal or
PC by using the set command or by pressing
BREAK
, typing AT and
pressing
RETURN
(providing the Autoadjust option is on).
To program any of the four stored profiles, follow this procedure.
1. At the CMD: prompt, type program p1 and press
RETURN
.
The ADM displays the current option values for p1 and prompt:
Type option name (or Q to quit):
2. Type the name of the option (for example, answer) you want to change
and press
RETURN
.
The ADM displays the current value and the possible values for that
option and prompt:
Type new value (or Q to quit):
3. Type the new value (for example, auto) and press
RETURN
when you are
finished.
4-23