User`s manual

Data Options and Profiles
Idle.timer
Option Values: 0.0 (off), .05 - 12.75 (seconds)
Applicable Data Protocols: X.25, Mode 3, BV64I, and BV56I
When the Data Mode is set to X.25, Mode 3, BV56I or BV64I, the ADM sends
data through the network in packets. If the time between characters exceeds the
idle.timer, less than the full packet will be sent out.
Interaction with Min.timer: An Idle.timer value greater than .05 seconds takes
precedence over the Min.timer.
Line.erase
Option Values: cancel
Ctrl
-
X
, NAK
Ctrl
-
U
, @, off
Applicable Data Protocols: X.25, Mode 3, BV64I, and BV56I
This option allows you to choose the character that erases the entire contents of
the editing buffer.
Like Char.erase, Line.erase is enabled only when Edit is enabled. Select the
character that best meets your needs. If you do not have
CANCEL
on your data
terminal, you can hold down
CONTROL
and press
X
. To use NAK, hold down
CONTROL
and press
U
.
The Line.erase character is not sent out in the data packet.
Local.cr
Option Values: Any ASCII character except NUL, SOH,
Ctrl
-
X
,
Ctrl
-
U
,
Ctrl
-
S
, BS (default = CR)
Applicable Data Protocols: N/A
This option selects the Local Mode command line termination character. Some
PC communications packages access this option from the AT Local Mode.
Individual users should not change this option value.
Unlike most data options, Local.cr is an unstored option (it is not stored in a
programmable profile), and its setting reverts to the factory default value upon
power-up.
Local.echo
Option Values: on, off
Applicable Data Protocols: N/A
This option selects whether characters entered in Local Mode are echoed back
to the user. Some PC communications packages access this option from the AT
Local Mode. Individual users should not change this option value.
4-9