User`s manual

Using the CMD and AT Commands
3. Type the value for that option (for example, 5552222). The ADM
responds by displaying a table of all values for this memory location and
prompts again:
Type option name (or Q to quit):
4. Type in the next option name for which you want to assign a value and
repeat Step 3. You will probably want to select a name (up to eight
characters) to correspond with each number so you do not have to
remember which number is stored in each memory location.
5. Type Q when you are done. The ADM responds:
Do you want to save the change(s) you made (Y or N)?
6. Type y to save the changes. The ADM saves your changes and displays
the following message:
m1 updated
7. Type n to cancel the changes. The ADM displays:
No changes made to m1
3-8