User`s manual

Getting Started
Checking the Status of a Data Call
1. If you have an 8510 or 8528 display terminal, press
Menu to access the
main softkey menu screen and then press
Next to access the second
menu screen.
If you have an 8520 display terminal, press
Menu to access the main
softkey menu.
2. Press the softkey associated with Data.
One of the following is displayed on the 8510 and 8528 display terminal
screen:
DATA (Not Active)
DataOptions Call Done
DATA (Call Connected)
DataOptions EndCall Done
One of the following is displayed on the 8520 display terminal screen:
DATA (Not Active)
Data Options
Call Done
DATA (Call Connected)
Data Options
End Call Done
NOTE:
If the data indicator is displayed during an active data call, you can press
the softkey associated with Data on the 8510 and 8528 display terminals
to access the same screens.
Making a Data Call From a Data Terminal
or PC Using CMD Local Mode Commands
The Local Mode option must be set for CMD Local Mode. See the ‘‘Setting
Critical Options to Make a Data Call’’ section earlier in this chapter.
2-26