User`s manual

Getting Started
Making a Data Call
You can use the softkeys of your 8500 series display terminal to initiate a data
call, or you can initiate it from your data terminal or PC. If you initiate the call
from your data terminal or PC, you can use CMD commands or AT commands.
Check the documentation from your PC communications package to determine if
you need to use AT commands. The procedures for all three methods follow.
Making a Data Call from your 8500 Series
Display Terminal
1. Turn on your data terminal or PC. If you are using a PC, make sure your
communications software is configured properly at the speed and parity
you want to use.
2. If you have an 8510 or 8528 display terminal, press
Menu to access the
main softkey menu screen and then press
Next to access the second
menu screen.
If you have an 8520 display terminal, press
Menu to access the main
softkey menu screen.
3. Press the softkey associated with Data.
The following is displayed on the 8510 and 8528 display terminal screen:
DATA (Not Active)
DataOptions Call Done
2-22