User`s manual

Getting Started
Resetting the Current Data Options
Refer to the section ‘‘Using Reset to Clear a Locked-up ADM’’ in Chapter 6.
Setting the Data Call Indicator
The data call indicator appears on the second line of the 8500 series display
terminal screen. If you set the data call indicator to Yes, the data call indicator
appears when you have established a data call. If you set the data call indicator
to No, the data call indicator will not be displayed during an active data call. To
set the data call indicator using the softkeys on your 8500 series display terminal,
do the following:
1. If you have an 8510 or 8528 display terminal, press
Menu to access the
main softkey menu screen and then press
Next to access the second
menu screen.
If you have an 8520 display terminal, press
Menu to access the main
softkey menu screen.
2. Press the softkey associated with Data.
3. Press the softkey associated with DataOptions or Data Options.
The following is displayed on the 8510 and 8528 display terminal screen:
DATA OPTIONS >
Change ViewCurrent Done
The following is displayed on the 8520 display terminal screen:
DATA OPTIONS
Indicator
Change Options Reset
View Current Done
2-19