User`s manual
Table Of Contents
- Contents
- Introduction
- Your ISDN 8510T Voice Terminal
- Feature Descriptions
- Voice Features
- Features Accessed with the Display and Softkeys
- ENTERING AND EXITING SOFTKEY MODE (USING THE MENU AND THE EXIT BUTTONS)
- THE VOICE TERMINAL SELF-TEST FEATURE bbbbbbb
- USING THE NEXT, THE PREV, AND THE DIR BUTTONS
- RESPONDING TO ´QUIT´ AND ´DONE´
- A SOFTKEY DISPLAY SCREEN FLOWCHART
- SETTING THE CLOCK
- SETTING THE SPEAKERPHONE
- ADDING, EDITING, AND DELETING A NUMBER AND NAME IN THE DIRECTORY
- VIEWING A DIRECTORY ENTRY (AND PLACING A CALL)
- USING THE DIR BUTTON TO PLACE A CALL
- USING THE CALL LOG
- LOCKING AND UNLOCKING THE DIRECTORY, CALL LOG, AND ALL SOFTKEYS
- CHANGING OR REMOVING YOUR PASSWORD
- SELF-TEST
- CHOOSING THE CONTRAST LEVEL FOR THE DISPLAY
- SELECTING A PERSONALIZED RING
- SETTING THE RATE AT WHICH YOU VIEW THE DISPLAY MESSAGES
- TURNING ON OR OFF SOFTKEY INFORMATION TONES
- SETTING THE NUMBER OF NAMES ON THE DIRECTORY PAGE
- Tones and Their Meanings
- Labeling and Installing the Designation Card and the Telephone Number Card
- Installation
- Technical Description
- Index
Number of Names (on a Directory Page)
Allows you to view
either
4 names
or
3 names + Quit on the second line of an individual Directory
page. If you choose to have 4 names on the Directory screen at one
time, you can leave the Directory or cancel calling a name in your
Directory only by pressing
Exit
(rather than using Quit).
Personalized Ring
Allows you to select your own personalized ringing
pattern from among 8 available patterns. Use to distinguish your voice
terminal’s ring from that of other nearby voice terminals.
Screen Timing (Rate at which the Display Message is Shown)
Allows you
to set the length of time the display message remains on the screen.
There are 3 rates: Slow, Medium, and Fast.
Self-Test
Performs a diagnostic test of your voice terminal including the
lights, ringer, dial pad keys, and display.
NOTE: When you perform a self-test of the voice terminal, it clears the
contents of the Call Log and the last number dialed from Redial, and
returns the volume control to the default setting.
Set Speakerphone
When you set the built-in speakerphone, it performs
a test of the surrounding environment and adjusts itself for optimal
performance.
Tones
A confirmation tone (sequential low and high tones) is provided
to let you know a selection has been accepted; an error tone (one beep)
alerts you that you made a mistake in your softkey entries. You may
choose to turn these softkey information tones on or off.
10