Instruction manual

CHAPTER 8. SYSTEM BACKUP FOR DEFINITY G3r
The command completion status is displayed on the screen, as shown below.
Save Translation
Processor
Command Completion Status
Error Code
SPE_A*
success/specific error message
nl
SPE_B*
success/specific error message
n2
* In a simplex system, only the active (default) SPE status is given. ln a duplex system if a qualifier is
used to select save translation for only one SPE, only that SPE’s status is given.
FIGURE 8-1. Save Translation Completion Status
The displayed information includes either a success message or an error message and error
code for each processor (see Table 8-A). A success message means both copies of translation
data were updated successfully on a particular device from the in-memory translation data. The
error code for each processor provides further information as to whether only one or two copies
of translation data were updated successfully. If only one copy was updated or neither copy was
updated, an alarm would be raised on that device so that the system technician can take
appropriate repair actions.
TABLE 8-A. Save Translation Command Error Codes
CODE interpretation
0
The save operation was a complete success;
both copies of translation data were updated.
1
The save operation was a partial success;
only
one of the two copies of translation data was updated.
2
The save operation failed completely; no translation
was saved to either
copy of translation data.
8-11