Instruction manual

CHAPTER 8. SYSTEM BACKUP FOR DEFINITY G3r
E31 (W)
E32 (W)
E33 (W)
E34 (W)
E35 (W)
E36 (W)
E37 (W)
E38 (W)
E39 (W)
E40 (W)
E41 (W)
E42 (W)
Announcement port in use; please try later.
One or more of the announcement ports are in use. The port could be in use for an
integrated announcements session or for integrated announcement playback.
Bad announcement file on tape (disk).
This message indicates that the announcement file stored on disk or tape is corrupt.
A valid file must be stored on the MSS before it can be accessed. This helps to
prevent overwriting valid announcements on the ANN board.
No announcements on board.
Announcements must be stored on the ANN board in order to proceed with com-
mand. This helps to prevent overwriting or corrupting a good annoucement file on
the MSS.
Announcement data module out of service.
This message indicates that the announcement
data module has been taken out of
service by maintenance. The data module could have been taken out of service
because of errors on the data module detected by maintenance.
Required system access port not administered or out of service.
A system
access port is either not available or is out of service.
Announcement data module not available.
Cannot access the announcement data module because the upload/download port is
active.
Tape access failure; no tape cartridge or tape drive failure.
No tape is in the tape drive.
Tape write failure; no tape cartridge or tape drive failure.
The tape is write protected.
Required system access port unavailable.
The required system access
port is unavailable.
Tape (disk) not formatted with announcement file.
Device must be formatted with the announcement file in order to read or write it.
Refresh currently in progress, please try again later.
MSS is in use by SPE duplication memory refresh. This is an indication to try the
command again later.
MSS device is maintenance busy.
8-8