Instruction manual

CHAPTER 6. HARDWARE RECONFIGURATION

Overview

Before voice terminals, trunks, and data modules can be added to the system, specific types of

circuit pack must already be installed in the cabinet. The System Manager must determine if the

required circuit pack exists in the system, and if a port on the circuit pack is vacant. If a vacant

port is not available, a circuit pack must be installed before the corresponding voice terminal or

trunk can be added.

The System Manager can use the Circuit Pack screen form to assign the circuit packs before

voice terminals, trunks, and data modules can be added to the system.

The system provides a set of commands that is used to display system and circuit pack (board)

configuration. These commands allow the System Manager to list the current system hardware

configuration. From this listing, the System Manager can determine if additional hardware (circuit

packs) is required.

When adding a new circuit pack, the carrier loading procedures in the Implementation manual

must be followed. All items must be entered for the Port Assignment Record.

The following commands are used to list system and circuit pack (board) configurations:

●

list configuration all

●

list configuration board (3-character board number)

●

list configuration station

●

list configuration trunk

●

list configuration control

●

list configuration software-vintage [long]

●

list configuration port-network (1-3)

●

list configuration carrier 2 character cabinet [1-3], carrier [A-E]

Whenever features are assigned to buttons on voice terminals, the associated button must be

labeled.

6-1