Instruction manual

CHAPTER 5. ADMINISTRATIVE TASKS-VOICE TERMINAL
For the 7500B Data Module, multipoint administration is allowed for terminals with Service Profile
Identification (SPID) initialization capabilities. if the
duplicate data-module command is used to
add a 7500B and the user wishes to add an SPID value which is different from the extension, the
SPID field must be modified after the Data Extension field is entered or modified.
The following commands can be used:
●
●
●
●
●
●
●
add data-module xxxx (ext. number or “next”)
If next is entered instead of an extension number, the system will automatically select
the next lowest available extension number. This command should not be used when
prefixed extensions have been assigned on the Dial Plan.
change data-module xxxx (ext. number)
display data-module xxxx (ext. number) [print]
duplicate data-module xxxx (extension number of data-module to be duplicated)
list data-module (starting ext. number) xxxx (count)
remove data-module or station xxxx (ext. number)
status data-module xxxx (extension number)
Hardware Requirements
A Digital Line circuit pack must be installed to avoid alarms before a PDM and Trunk Data
Module (TDM) can be administered. A TN726 Data Line circuit pack is needed for data line-type
data modules. A TN750 circuit pack is needed for the Recorded Annoucement
data module.
5-10