Instruction manual

CHAPTER 4. ADMINISTRATIVE TASKS-SYSTEM
All four Netcon channels must be assigned. The following steps can be used to add a data or
Netcon channel:
1.
2.
3.
4.
5.
6.
7.
8.
9.
10.
11.
12.
13.
14.
15.
16.
Verify that the terminal displays:
enter command:
Enter add data module 4444 where 4444 is the extension number assigned to the
Netcon channel. The extension number will appear in the
Data Extension field on the
screen form. Press [RETURN]. The screen displays a Processor Data Module (PDM)
form. The cursor is positioned on the TYPE field.
In the TYPE field, enter netcon and press [RETURN].
Screen displays the Netcon Channel form.
The cursor is positioned on the
Physical Channel field.
Enter a Netcon channel number from 01 through 04 and press [RETURN].
The cursor is positioned on the Name field.
Make no entry and press [RETURN].
Cursor is positioned on the COS field.
Enter a COS number from 0 through 15 and press [RETURN].
The cursor is positioned on the COR field.
Enter a COR number from 0 through 63 that will allow or deny access and press
[RETURN].
The cursor is positioned on the Abbreviated Dialing (AD) List 1 field.
Make no entry and press [ENTER].
The screen displays:
command successfully completed,
enter command:
Repeat Steps 1 through 16 until all four Netcon channels have been established. A dif-
ferent extension number must be entered for each Netcon channel. The system
automatically assigns the extension number if next is entered at the end of the add
data-module
command (add data-module next).
The Netcon channels can be added by entering the command duplicate data-module xxxx
(extension number to be duplicated). This command must be entered for each Netcon chan-
nel being added.
If the system is administered for these features, after all four Netcon channels have been
assigned, the user can refer to “How to Administer System From a Remote Location” in this
chapter for more information.
4-7