Instruction manual

CHAPTER 3. SYSTEM ADMINISTRATION

These items cannot be added to the system; however, they can be changed to suit business

needs by entering the

change

command for that feature and changing the screen form. The

add

command must be used to add trunks, pickup groups, hunt groups, and intercom groups. The

duplicate

command can be used to duplicate voice terminals and data modules.

Once all the forms have been grouped, the System Manager can log into the system using the

terminal and receive the

enter

command:

prompt. The System Manager can change the pass-

word, if so desired.

Establish a Dial Plan

The Dial Plan and Feature Access Codes (FACs) must be administered before voice terminals,

hunt groups, pickup groups, coverage groups, and attendant consoles can be administered. The

default values for the Dial Plan can be changed if they do not meet business requirements. The

Dial Plan can be changed by entering the command

change

dial plan and then changing the

default values on the screen form. The Dial Plan can use up to 5 digits.

Feature Access Codes

The defaulted values on the FAC form can be changed if they do not meet business require-

ments. FACs can be changed by entering the command

change feature-access-codes

and

then changing the

default values on the screen form. The number of digits assigned to the FAC

must agree with the Dial Plan.

System Features

System features include the Class of Service (COS) and Class of Restriction (COR). These

features cannot be added; they can only be changed. To change these system features, enter

the command

change cos

for COS or

change cor 0-63

for COR. Once the screen form is

displayed, the data entries can be changed.

Console Parameters and Attendant Consoles

Attendant consoles must be added one at a time. A vacant port on a digital line circuit pack is

required for each attendant console used. For reliability, attendant consoles should not be

assigned to the same circuit pack.

3-2