Instruction manual

SYSTEM BACKUP FOR DEFINITY G3s
9.
10.
11.
12.
13.
14.
Memory Card is not inserted in the system
Response: Insert the Memory Card.
Cannot access file; wrong type of Memory Card is inserted
You have not inserted the correct Memory Card for the operation you wish to perform.
Load the appropriate Memory Card.
File size exceeded
You have run out of file space.
Response: Call your AT&T representative.
Upgrade Memory Card inserted
You may have inserted the System Upgrade Memory Card instead of the 4 Mb Memory
card.
Response: Insert the 4 Mb Memory Card.
Memory Card is write-protected
Indicates the switch on the top side of the Memory Card is incorrectly set.
Response: Move the switch to the correct position with the point of a pencil or similar
object. Refer to the figure below:
FIGURE 1-3. Memory Card Write-Protect Switch
Transmission problem; please try later
There is a problem communicating with the announcement board.
Response: Check to see that the announcement board has been correctly administered.
Use the
change data <extension_number> command. Verify that the announcement
board is in the correct slot in the processor. It the location of the announcement board is
correct, use the
display data <extension_number of netcon data modules> to verify that
the data modules are allowed to originate calls to the announcement board. Use
display
data <extension_number of the announcement data module> to verify that the data
module on the announcement board is allowed to terminate calls from the netcon data
modules. Note that the netcon data modules must also be allowed to call each other. If
all is correct, wait and retry.
1-5