Instruction manual

SYSTEM PARAMETERS
TABLE H (continued).
Station Allocation Characteristics
Station Type
Required Records
Required Records and
(G1,G3)
Button Units*
Basic Attendant Console
A+2B
A
Enhanced Attendant Console
A+2B
A
Attendant Selector Console
A+2B
A
Feature Module
[B]
240
Display
B
**
DTDM
M
M
MPDM/MTDM/7400A/7400B M
M
/7500B
Call Coverage Module
B 200
EIA (PI-Simplex)
M
M
CDR
M M
Netcon Data Channel
2M 2M
Processor Interface Link
2M
2M
[ISDN sets for G3 only]
ISDN-BRI UDM -7500
M+I
ISDN-BRl set -7505
S+I+190
ISDN-BRI set -7506 w/display S+I+250
ISDN-BRI set -7507 w/display
S+I+480
ISDN-BRI set - 8503T S+I+50
LEGEND:
*
—
—
*
—
—
Assumes 3 call appearances per station in button 1-3 with all other available buttons assigned.
For call appearances other than 3, adjust total units by the following:
adjustment=(Nca-3)*[(10*Ndisp)+(6*Nbri)]
where: Nca=number of call appearance (assumes first Nca button is CA)
Ndisp=total number of display stations in system
Nbri=total number of BRI station in system
Assumes 3 call appearances per station in button 1-3 with all other available buttons assigned.
For call appearances other than 3, adjust total units by the following:
adjustment=(Nca-3)*[(10*Ndisp)+(6*Nbri)]
where: Nca=number of call appearance (assumes first Nca button is CA)
Ndisp=total number of display stations in system
Nbri=total number of BRI station in system
** For G3, the number of button memory units required for a display depends on the station type. The number of button
memory units required for a display is indicated for each station type in the table above. Note that these values
depend on the assumptions in the previous footnote. (Call appearances are only translated on buttons 1-3.)
69