Instruction manual

FEATURE DETERMINATION
TABLE F (continued).
Features Requiring Additional Hardware and/or Software
Hardware and/or Actual
Feature Software Hardware and/or
Required Software Needed
Service Observing Requires Service Observing Software.*
Station Identification/ For G1, G3i, or G3i-Global, assign an Inter -
Automatic Number Identif -
face Link (requires a TN765 Processor
ication (SID/ANl) (G1
Interface circuit pack) for a direct EIA-232
name) Calling Party
connection (if not already used). Alter-
Number/Billing Number
nately, a data module and TN754B Digital
(CPN/BN) (G3)
Line port can be used.
For G3r or G3i-Global, a TN464 Universal
DS1 circuit pack is used. Note that the link
is administered on the System’s Processor
Channel Assignments form. The link is
used as an interface to a CallVisor ISDN
Gateway adjunct (3B2 Processor) in support
of SID/ANl (G1) or CPN/BN (G3). Requires
display terminals.
Requires ACD-related hardware also. Refer
to the ACD feature coverage elsewhere in
this table.
Requires ISDN-PRI software and CallVisor
ISDN Gateway software.*
Subnet Trunking
Additional TN748C or, depending on coun -
try, TN420B or TN420C circuit packs, if
Routing Patterns containing “wait” symbols
are used heavily, and if dial tone detection is
preferable to waiting for interval time-out.
Private Networking, UDP, or ARS software.
DCS software is optional.
Ten-Digit to Seven-Digit
Either ARS and Private Networking software
Conversion (G1 Only)
or ARS and UDP software.
Time of Day Routing
Time of Day Routing software. ARS
software.
Uniform Dial Plan (UDP)
A Processor Interface circuit pack is
required for DCS applications.
UDP software.
* Software is activated by enabling this feature on the System Parameters Customer Options form.
55