Instruction manual

FEATURE DETERMINATION
TABLE F (continued).
Features Requiring Additional Hardware and/or Software
Hardware and/or
Actual
Feature
Software
Hardware and/or
Required Software Needed
Loudspeaker Paging
Loudspeaker paging equipment and one
Access
port on a TN763 Auxiliary Trunk circuit pack
per zone. Paging interface equipment, con -
sisting of a 278A Adapter (only if equipment
is not FCC-registered) and a 24-volt power
supply, per zone. (This hardware can be
shared with the Code Calling Access
feature.)
If PagePac® paging system equipment is
used, one port on a TN747 CO Trunk circuit
pack, any 16 port Analog Line circuit pack
(see Table T for the correct circuit packs per
country), TN763 Auxiliary Trunk circuit pack
(depending on the PagePac arrangement
used).
Loudspeaker Paging
See Loudspeaker Paging Access.
Access-Deluxe
M-to-N Digit Conversion
Either ARS and Private Networking software
(G3)
or ARS and UDP software.
Modem Pooling
One TN758 Pooled Modem circuit pack per
two integrated conversion resources pro -
vialed. Each combined conversion resource
requires one port on the Digital Line circuit
pack and one port on an Analog Line circuit
pack, along with an analog modem and
MTDM or 7400A Data Module.
Move Agents From Call ACD software and a CMS adjunct.
Management System
(CMS)
Music-on-Hold Access A music source and one port on a TN763
Auxiliary Trunk circuit pack. Also, a 36A
Voice Coupler if the system is not FCC-
registered.
Names Registration
See Property Management System (PMS)
feature for hardware requirements.
* Software is activated by enabling this feature on the System Parameters Customer Options form.
51