Instruction manual

FEATURE DETERMINATION
TABLE F (continued).
Features Requiring Additional Hardware and/or Software
Hardware and/or
Actual
Feature
Software Hardware and/or
Required Software Needed
Emergency Access to
Emergency Access to Attendant software.*
Attendant
Same hardware and software as for DCS
features.
Facility Restriction Levels
FRLs—ARS and/or Private Networking
(FRLs) and Traveling
software*
Class Marks (TCMs)
TCMs—Private Networking software and
intertandem tie trunks.*
Forced Entry of Account
CDR Account Code Dialing software.*
Codes
Generalized Route
AAR, ARS, and ISDN-PRI services
Selection software.*
Hunting
ACD requires ACD software. Call Vectoring
is required for vector-controlled splits.
Inbound Call Management Requires CallVisor ASAI hardware (refer to
(lCM)
the CallVisor ASAI feature for hardware
requirements).
Requires use of the ACD feature (refer to
the ACD feature for hardware require -
ments).
May use Call Prompting. Refer to the Call
Prompting feature for hardware require -
ments.
Requires CallVisor ASAI software.*
Information System Net -
One TN726 Data Line circuit pack per eight
work (ISN) Interface
ISN interfaces.
Integrated Services Digital
One TN556 ISDN-BRI circuit pack for up to
Network-Basic Rate
12 BRI (2B+D) endpoints using the 4-wire T
Interface (ISDN-BRI)
interface. It also supports up to 24 end -
points in a passive bus arrangement. The
circuit pack supports the frame relaying of
ISDN Packet Mode data in either the
D-channel or one of the B-channels, but G3i
software will support only circuit switching of
Mode 3 in the B-channel.
For G3i or G3i-Global, the system must be
equipped with a Packet Control (TN778) cir -
cuit in order to support this circuit pack. For
G3r, all TN776 Expansion Interface circuit
packs must be replaced by TN570 Expan -
sion Interface circuit packs.
* Software is activated by enabling this feature on the System Parameters Customer Options form.
49