Instruction manual

FEATURE DETERMINATION
TABLE F (continued).
Features Requiring Additional Hardware and/or Software
Feature
Digital Multiplexed Inter-
face (DMI)
Direct Department Calling
(DDC) and Uniform Call
Distribution (UCD)
Direct Inward Dialing
(DID)
Direct Inward/Outward
Dialing (DOD)
Hardware and/or
Software
Required
For G1 or G3i, one TN722 or TN767 DS1
circuit pack per 24 DMI trunks.
For G3i-Global, one TN722 ore TN767 DS1
circuit pack per 23 DMI trunks. If ISDN-PRI
is used, a TN765 Processor Interface circuit
pack is also required.
For G3r, one TN464 per 24 DMI trunks.
One port on a 16-port Analog Line circuit
pack per queue warning level lamp, if
needed (see Table T for the correct circuit
pack for each country).
Announcement equipment and one port on
a 16-port Analog Line circuit pack per ana -
log delay announcement (again, see Table
T for the correct circuit pack for each coun-
try). If music is to be heard after the delay
announcement, a music source and a port
on a TN763 Auxiliary Trunk circuit pack is
required. A TN750B Announcement circuit
pack can be used to provide up to 64 dif -
ferent announcements.
One port on an Analog DID Trunk circuit
pack (see Table S for the correct circuit
pack for each country) or TN722/TN767/
TN464 DS1 circuit pack for each DID trunk.
For G3i-Global, if MFC signaling is to be
used for DID, a TN744B Call Classifier cir -
cuit pack of vintage 4 is required. In Mex-
ico, if you will have both DID and DOD using
MFC signaling, instead of TN744Bv4, you
need TN744Bv6. For more generalized
MFC support, you need TN744Bv7.
For G3i-Global, requires the TN429 DIOD
Trunk circuit pack.
Actual
Hardware and/or
Software Needed
* Software is activated by enabling this feature on the System Parameters Customer Options form.
47