Instruction manual

FEATURE DETERMINATION
TABLE F (continued).
Features Requiring Additional Hardware and/or Software
Hardware and/or Actual
Feature
Software
Hardware and/or
Required Software Needed
Code Calling Access
Loudspeaker paging equipment and one
port on a TN763 Auxiliary Trunk circuit pack
per zone. (These hardware requirements
can be shared with the Loudspeaker Paging
Access feature.)
D-Channel Backup
Requires DS1 and ISDN-PRI facilities.
Refer to ISDN-PRI for associated hardware
and software requirements. Note that
TN767 DS1 circuit pack does not provide
DSO. TN464 Universal DS1 circuit pack
does provide DSO.
Data Call Setup
Each data module requires one port on a
TN754B Digital Line circuit pack. [A Digital
Terminal Data Module (DTDM) shares the
port with the associated voice terminal.]
Each AT&T 510D or 515 BCT requires one
port on a TN754B Digital Line circuit pack
for shared use of voice and data.
Each digital voice terminal requires one poti
on a TN754B Digital Line circuit pack for
shared use of voice and data.
Each modem requires one port on a TN746
Analog Line circuit pack.
For modem pooling, requires either a TN758
Modem Pool circuit pack (two conversion
resources per board) or one digital port with
a Trunk Data Module or Modular Trunk Data
Module (MTDM), and one analog port with
an analog modem for each conversion
resource.
For G3i-Global, a TN726B Data Line circuit
pack can be used to provide direct data ter -
minal access.
Keyboard Dialing to off-premises (out of
building) data endpoints requires the use of
a TN748C, TN420B, or TN420C Tone
Detector circuit pack (depending on country
- see Table R).
Extensive use of features and services
using tone detection may require additional
TN748C, TN420B, or TN420C circuit packs
(several other features also use a TN748).
45