Instruction manual

FEATURE DETERMINATION
TABLE F (continued).
Features Requiring Additional Hardware and/or Software
Hardware and/or Actual
Feature
Soflware Hardware and/or
Required Software Needed
Automatic Wakeup
For customized recorded announcements, a
model HQD614B Recorder/ Announcer
manufactured by the Audichron® Company
is required. This equipment requires a 48-
volt power supply. Each Recorder/
Announcer requires four auxiliary trunk ports
on the TN763 Auxiliary Trunk circuit pack.
Basic Call Management BCMS Measurements software.*
System (BCMS)
Call-By-Call Service
For G1 or G3i, a TN767 DS1 circuit pack,
selection
TN768 Tone Clock circuit pack, and a
TN765 Processor Interface circuit pack. For
G3r, a TN464 Universal DS1 circuit pack,
TN768 Tone Clock, and a TN553 Packet
Data circuit pack. For G3i-Global, a TN767
DS1, TN741 Tone Clock or TN768 Tone
Clock circuit pack and a TN765 Processor
Interface circuit pack
Requires ARS software and ISDN-PRI
software.*
Call Detail Recording Hardware requirements depend on the type
(CDR) of output device used for CDR. For G3i or
G3i-Global, the CDR output device can be
connected directly to the Processor circuit
pack (TN759 or TN773) which provides a
standard EIA-232C interface. This elim -
inates the need for a data module as
described for the output devices given
below. For G3r, the CDR output device is
connected to a TN553 Packet Data circuit
pack, which is connected to a TN726 Data
Line circuit pack
A printer, personal computer, tape unit, or
the TELESEER® CDR unit (Data Terminal
Equipment)—a Modular Processor Data
Module (MPDM) to a port on a TN754 Digi -
tal Line circuit pack or a 212A-type modem
to a port on a TN746 Analog Line circuit
pack. In the latter case, a standard pooled
modem is required for the data path.
* Software is activated by enabling this feature on the System Parameters Customer Options form.
42