Instruction manual

FEATURE DETERMINATION
TABLE F (continued).
Features Requiring Additional Hardware and/or Software
Hardware and/or
Actual
Feature Software
Hardware and/or
Required Software Needed
Automatic Call
Each analog announcement requires
Distribution (ACD)
announcement equipment and one port on a
TN746 Analog Line circuit pack for G1, G3i,
or G3r, and any 16-port Analog Line circuit
pack for G3i-Global (see Table T). Each
announcement, accessed by a call, requires
one port on a TN750B Announcement circuit
pack.
If music is to be heard after the delay
announcement, a music source and a port
on a TN763 Auxiliary Trunk circuit pack is
required.
Appropriate voice terminals are required for
agents. 2500-type sets are not recom -
mended.
ACD software is required.*
Automatic Circuit
Any Speech Synthesizer circuit pack (see
Assurance
Table Q for the correct circuit pack for each
country) is required if the referral destination
is not a display-equipped voice terminal.
Automatic Incoming A515 BCT, display-equipped voice terminal,
Call Display or a voice terminal capable of displaying
information through an attached data termi -
nal. The terminals require a PRI or DCS
link; otherwise they are station to station
only.
Automatic Route
ARS software and ARS Digit Conversion.*
Selection (ARS)
Automatic Route
For G1, G3i, and G3r, additional TN748 tone
Selection (ARS)
detectors, or, for G3i-Global, TN420B or C
Partitioning tone detectors (choice depends on the
country involved).
Automatic Wakeup
If voice prompting is used, a Voice (or
Speech) Synthesizer circuit pack is required.
See Table Q for the correct circuit pack for
each country. Each circuit pack has four
ports to provide voice prompting. If voice
synthesis announcements are used, two
ports must be reserved for announcements.
* Software is activated by enabling this feature on the System Parameters Customer Options form.
41