Instruction manual

CONFIGURATION GUIDELINES
Page x of 5
CARRIER yx
Slot Code
Sfx
Name
Slot Code Sfx Name
01: _ 11: _
02: _ 12: _
03: _
13: _
04: _
14: _
05: _
15: _
06: _
16: _
07: _ 17: _
08: _ 18: _
09: _ 19: _
10: _ 20: _
'#'
indicates circuit pack conflict * Use slots 01-18 with
* J58890H-1 carrier.
FIGURE 10. Circuit Pack Administration Forms (continued)
Implementation Note:
CARRIER xy: x = Port Network Number (1-3), y = Carrier Letter (A-E)
Multicarrier Cabinet: The number of circuit pack forms and associated pages to be completed
is dependent on the multicarrier system configuration. For example, a multicarrier PPN cabinet
With Duplication requires one control carrier (use one circuit pack CARRIER 1A form), one dupli-
cated control carrier (use one circuit pack CARRIER 1A form), and up to three port carriers (use
three circuit pack CARRIER xy forms—one for each port carrier). For a PPN cabinet, mark each
circuit pack form as “PPN.” In the above example five forms must be completed.
When an EPN is supported, the Expansion Control carrier requires one circuit pack CARRIER 2A
form to be completed in addition to a circuit pack CARRIER xy form for each port cabinet in the
EPN configuration. Mark the associated circuit pack forms as “EPN 1 or EPN 2,” as appropriate.
Use the circuit pack code (TN number) when assigning the circuit packs to slots.
Single-Carrier Cabinet: The number of circuit pack forms and associated pages to be com-
pleted is dependent on the single-carrier cabinet system configuration. For example, a PPN With
Duplication requires one control cabinet (use one circuit pack CARRIER 1A form), one duplicated
control cabinet (use one circuit pack CARRIERS 1A form), and up to two port cabinets (use two
circuit pack CARRIER xy forms—one for each port cabinet). For a PPN cabinet, mark each cir-
cuit pack form as “PPN."
In this example, four forms must be completed.
26