User`s guide

E-1
Issue 3 October 1995
E
Result codes (Table E-1) are informational messages sent from
the DataPort PCX modem and displayed on your monitor. They
can inform you of the status of a call (RING, NO ANSWER),
whether or not a command is valid (OK, ERROR), or at what
rate the modem has connected (CONNECT 14400). Refer to the
Q
n , V n , and X n commands in Appendix B for more information.
Table E-1.
DataPort PCX Result Codes (1 of 2)
Numbers
(ATV0)
Word
(ATV1)
Description
0 OK Command executed
1 CONNECT Modem connected to line
2 RING Modem receiving a ring voltage
from the dial line
3 NO CARRIER Modem lost or does not detect
carrier signal, or does not detect
answer tone
4 ERROR Invalid command
5 CONNECT 1200
1
Connection at 1200 bps
6 NO DIALTONE
2
No dial tone detected
7 BUSY
3
Busy or trunk busy signal detected
8 NO ANSWER No ‘‘quiet” answer @
9 CONNECT 0600
1
DTE connection at 600 bps
10 CONNECT 2400
1, 4
Connection at 2400 bps
1
For ATX0, result code 1 or CONNECT is displayed instead.
2
For ATX0 and X1, result code 3 or NO CARRIER is displayed instead.
3
For ATX0, X1, and X2, result code 3 or NO CARRIER is displayed instead.
4
Refers to DTE rate or DCE rate depending on setting of ATW n .