User`s guide

AT Commands and S-Registers

B-11

Issue 3 October 1995

Table B-1. AT Command and S-Register List (11 of 21)

AT Command/

S-Register

Description

S95 EXTENDED RESULT CODES

Sets an override of the W

command option.

NOTE: The following values are bit positions, not

decimal S-register contents. An option is selected if

its associated bit is set to 1.

0 = CONNECT result code shows DCE speed instead

of DTE speed

1 = Reserved

2 = Enable CARRIER

result code (

=rate)

3 = Enable PROTOCOL NONE result code

4–7 = Reserved

T TONE DIAL

Specifies touch-tone dialing. This is the default type.

(See D

n.)

RESULT CODE FORMAT

Determines the way result codes are sent to the DTE.

V, V0 Result codes displayed as numbers

V1 Result codes displayed as text

CONNECT MESSAGE CONTROL

Controls the format of the CONNECT result code

displayed upon connection (only).

W0 CONNECT shows DTE rate

W1 CONNECT shows VF rate, protocol, and

DTE rate

W2 CONNECT shows VF rate