Specifications

Group Call Distribution
Use this communications system procedure to specify a new outside line on
which you want Automated Attendant Service.
Update Line Coverage on Form A, Page 1 of 2 of the System Planner for the
communications system to show modifications to VMS-AA lines before you
begin.
To assign VMS-AA lines to Hunt Group 7:
1.
2.
3.
4.
5.
6.
7.
8.
9.
10.
Press [ Feature ]
[0] [0] [ System Program ] [ System Program ] .
Enter the System Password, if required.
Press [#] [2] [0] [6] * .
At the Group: prompt press [7] .
At the Line: prompt, enter the first VMS-AA line to be programmed as
specified in the Line Coverage column of Form A, Page 1 of 2.
Press [ Next Data ] until the display reads 1 Assigned. (Be careful not to
choose
3 VMS Line Cover because you will assign VMS Line Coverage
rather than Automated Attendant Service to the line.)
To program another line, press [ Next Item ] or [ Prev Item ] until the appropriate line
number displays.
Press [ Next Data ] until the display reads 1 Assigned.
Repeat Steps 7 and 8 for each VMS-AA line.
Press [ Feature ] [0] [0] to exit programming.
VMS Hunt Delay
Use this communications system procedure to specify either immediate or
delayed call handling.
Update Form A, Page 2 of 2 of the System Planner for the communications
system to show modifications to the VMS Hunt Delay setting before you begin.
To change the VMS Hunt Delay setting:
1. Press [ Feature ] [0] [0] [ System Program ] [ System Program ] .
2.
Enter the System Password if required.
3. Press [#] [5] [0] [6] .
4. Press [ Next Data ] until the appropriate value displays.
5.
Press [ Feature ] [0] [0] to exit programming,
*
In some countries, the procedure code for Group Call Distribution is #205, Check the Programming and Use
guide for the communications system.
5-26 System Management