Specifications

Voice Mail Messages

This intercom Auto Dial button allows the subscriber to access the voice

messaging system with the touch of one button.

To program a Voice Mail Messages (VMMsgs) button as specified on Form C:

Press [ Feature ] [0] [0] [ System Program ] [ System Program ] [Central Tel Program ] .

Dial the number of the extension to be programmed.

Press a programmable button.

Press left [ Intercom ] [7] [7] [7] .

At this point, do one of the following:

■

Press [ Central Tel Program ] and go to Step 2 of any button programming

procedure in this section to program a button for a different extension.

■

Press [ Feature ] [0] [0] to exit.

Verifying System Operation

After you finish programming the voice messaging system and the

communications system, you should perform the tests described in this section

to verify system operation.

If your system allows programming from extension 11 *, you should perform these

tests from extension 11 to keep extension 10 free for the receptionist to handle

calls.

Voice Mail Service

Make a call to the VMS Hunt Group by pressing

[ Intercom ] [7] [7] [7]

or the

programmed VMMsgs button, You should hear the Voice Mail Service greeting:

Welcome to PARTNER MAIL VS. Please enter extension

and # .

Otherwise,

to access PARTNER Tutor, press * 4.

Some systems allow programming from extension 11. Check the Programming and Use guide for the

communications system.

4-20 Initial Programming