Specifications

Telephone Button Programming
Before you begin, locate Form C of the System Planner for the communications
system. Be sure you have a version of the form for each subscriber’s phone.
Use this section to program buttons on subscribers’ phones, including the
receptionist’s phone. This section uses Centralized Telephone Programming.
When you are finished programming, be sure to label all buttons on subscribers’
phones.
VMS Cover
This button allows the subscriber to turn voice mail coverage on and off.
To program a VMS Cover button as specified on Form C:
1.
Press [ Feature ] [0] [0] [ System Program ] [ System Program ] [ Central Tel Program ].
2. Enter the number of the extension to be programmed.
3.
Press a programmable button with lights.
4.
Press [ Feature ] [1] [5] *.
5.
At this point, do one of the following:
■ Go to Step 3 of the next procedure to program another button for this
extension.
■ Press [ Central Tel Program ] and go to Step 2 of any button programming
procedure in this section to program a button for a different extension.
■ Press [ Feature ] [0] [0] to exit.
*
In some countries, the feature code for VMS Cover is [1] [6]. Check the Programming and Use guide for the
communications system.
4-18 Initial Programming