Specifications
Automatic VMS Cover
Check Form B2 to see if Automatic VMS Cover is assigned to any extensions. If
it is, follow the procedure below. If not, skip to “VMS Cover Rings.”
To change the Automatic VMS Cover setting for an extension to Assigned as
indicated on Form B2:
1.
2.
3.
4.
5.
6.
7.
Press [#] [3] [1] [0].
Enter the number of the first extension to which Automatic VMS Cover is to be
assigned.
Press [ Next Data ] until the display reads
1 Assigned.
T
O
program another extension, press [ Next Item ] or [ Prev Item ] until the extension
number shows on the display.
Press [ Next Data ] until the display reads
1 Assigned...
Repeat Steps 4 and 5 for each extension to which Automatic VMS Cover is to
be assigned.
Continue with “VMS Cover Rings” below.
VMS Cover Rings
Check Form A, Page 2 of 2, to see if VMS Cover Rings (#117)* is different from
the factory setting of 3. If it is, follow the procedure below beginning with Step
1. If not, skip to Step 3 of the procedure below.
To change the number of times calls ring before they are sent to the voice
messaging system as indicated on Form A, Page 2 of 2, VMS Cover Rings:
1.
Press [#] [1] [1] [7] .
2.
Enter the VMS Cover Rings setting specified on Form A.
3.
Press [ Feature ] [0] [0] to exit programming mode.
4.
Continue with the next section, “Telephone Button Programming,”
*
VMS Cover Rings (#117) is not available on all systems. Check the Programming and Use guide for the
communications system.
Initial Programming 4-17