Specifications

Line Ownership
Before you begin, locate Form 6 for the voice messaging system.
■
If Form 6 is filled out, use the procedure below to assign ownership.
■
If Form 6 is not filled out, skip to “Communications System Programming. ”
Assigning Line Ownership
To assign an owner to an outside line as specified on Form 6:
1.
2.
3.
4.
5.
6.
7.
8.
If necessary, access the Programming Main Menu. If you are already at the
Programming Main Menu, skip to Step 2.
a. Press [ Intercom ] [7] [7] [7] or the programmed VMMsgs button.
b. Press [9] [9] [#] .
c. Enter the Mailbox Password and press [#]
.
d. Press [9]
.
Press [6]
for Line Ownership.
Press [4]
to assign Line Ownership.
Enter a line number specified in Column A of Form 6, followed by [#]
.
Enter the line owner’s mailbox number specified in Column D of Form 6,
followed by [#] .
Repeat Steps 4 and 5 for each owned line.
Hang up to exit voice messaging system programming,
Refer to the next section to program the communications system.
4-12 Initial programming