Specifications

Initial System Setup
For the following two procedures, you need to know the extension numbers
associated with the PARTNER MAIL VS system module. Figure 2-1 (in Chapter
2) shows the possible extension numbers. For the extension numbers
appropriate to this installation, locate Form B1 of the System Planner for the
communications system.
VMS Hunt Group Extensions
You must use this procedure to assign the extensions associated with the voice
messaging system module to Hunt Group 7. This Hunt Group, which is called
the VMS Hunt Group, is used exclusively for the voice messaging system.
To assign the PARTNER MAIL VS extensions specified on Form B1 to Hunt
Group 7:
1.
2.
3.
4.
5.
6.
7.
8.
9.
10.
At extension 10*, press [ Feature ] [0] [0] [ System Program ] [ System Program ] .
Enter the System Password if required.
Press [#]
[5] [0] [5] .
At the Group: prompt, press [7]
.
At the Extension: prompt, enter the first PARTNER MAIL VS extension
number specified on Form B1.
Press [ Next Data ] until the display reads 1 Assigned.
Press [ Next Item ] or [ Prev Item ] until the next PARTNER MAIL VS extension number
specified on Form B1 displays.
Press [ Next Data ] until the display reads 1 A SS igned.
If additional PARTNER MAIL VS extensions are specified on Form B1, repeat
Steps 7 and 8 for each one.
Continue with “Transfer Return Extensions” on the next page.
*
Some systems also allow programming from extension 11. Check the Programming and Use guide for the
communications system.
4-2 Initial Programming