Specifications

■
Repair Instructions: If you experience trouble because your equipment
is malfunctioning, the FCC requires that you disconnect the equipment
from the network and not use it until the problem has been corrected.
Repairs to this equipment can only be made by the manufacturer, its
authorized agents, or by others who may be authorized by the FCC. In
the event repairs are needed on this equipment, please contact the AT&T
National Service Assistance Center (NSAC) at 1 800 628-2888. For
warranty information, see Appendix C.
Rights of the Local Telephone Company: If this equipment causes
■
harm to the telephone network, the local telephone company may
discontinue your service temporarily. If possible, they will notify you in
advance. But if advance notice is not practical, you will be notified as
soon as possible. You will also be advised of your right to file a complaint
with the FCC.
Your local telephone company may make changes in its facilities,
equipment, operations, or procedures that affect the proper
functioning of this equipment. If they do, you will be notified in
advance to give you an opportunity to maintain uninterrupted
telephone service.
DOC Notification and
Repair Information
The Canadian Department of Communications (DOC) label identifies certified
equipment. This certification means that the equipment meets certain
telecommunications network protective, operational, and safety requirements.
The DOC does not guarantee the equipment will operate to the user’s
satisfaction.
Before installing the equipment, users should ensure that it is permissible to
connect it to the facilities of the local telecommunications company. The
equipment must also be installed using an acceptable method of connection. In
some cases, the company’s inside wiring for single-line individual service may
be extended by means of a certified connector assembly (telephone extension
cord). The customer should be aware that compliance with the above
conditions may not prevent degradation of service in some situations.
Repairs to certified equipment should be made by an authorized Canadian
maintenance facility designated by the supplier. Any repairs or alterations
made by the user to this equipment, or any equipment malfunctions, may give
the telecommunications company cause to request the user to disconnect the
equipment.
Users should ensure for their own protection that the electrical ground
connections of the power utility, telephone lines, and internal metallic water pipe
system, if present, are connected. This precaution may be particularly
important in rural areas.
CAUTION:
Users should not attempt to make such connections themselves, but
should contact the appropriate electrical inspection authority or
electrician, as appropriate.
B-2 FCC Information